There are 3 types of faults a reverse fault, strike slip fault, and a normal fault. Normal Faults and Reverse Faults are "Dip-Slip" Faults - they experience vertical movement, in line with the dip of the fault. A reverse fault involves contraction along its fault plane, this involves the hanging wall moving up in relation to the footwall.

Strike Slip Fault .

In this fault…

Some of the differences between a normal fault and a reverse fault are as follows; (i) A normal fault is caused by tensional forces while a reverse fault occurs due to compressional forces. Normal fault and reverse fault are two types of fault in geology.

They are caused by extensional tectonics.

In a Normal Fault, the hanging wall moves downwards relative to the foot wall. A normal fault is a fault that involves extensional movement along its fault plane, this involves the hanging wall moving down in relation to the footwall. Given the angle of the fault, the upper red line is on the footwall, the lower red line is on the hanging wall. Normal Faults and Reverse Faults are "Dip-Slip" Faults - they experience vertical movement, in line with the dip of the fault. Normal faults often occur in pairs, with one being the main fault and the other being a smaller conjuagate fault. Faults are located where the tectonic plates meet.

A reverse fault occurs at an convergent boundary. REVERSE: Reverse faults are at convergent plates.

STRIKE-SLIP: Strike-slip faults occur at transform plate boundaries. A; A normal fault; B; A strike-slip fault; C; A dip fault; D; A reverse fault; E; An anticlinal fault; View answer Hide answer; D :: A reverse fault; 2.

What do we call a fault in which the hanging wall moves up along the dip with respect to the footwall (as pictured)? NORMAL: Normal faults occur at divergent plate boundaries.

a fault in which the rock above the fault plane is displaced upward relative to the rock below the fault plane (opposed to gravity fault). The main difference between normal fault and reverse fault is that normal fault describes the downward movement of one side of the fault with respect to the other side whereas reverse fault refers to the upward movement of one side of the fault with respect to the other side. They are identified by the relative movement of the Hanging Wall and Foot Wall. Fault is a fracture or crack where two rock blocks slide past one to another.

This fault is opposite to the normal fault. Types of faults include strike-slip faults, normal faults, reverse faults, thrust faults, and oblique-slip faults.

Normal fault in Mosaic Canyon, Death Valley. In a Normal Fault, the hanging wall moves downwards relative to the foot wall. Reverse Fault: A fault in which hanging wall has apparently gone up with respect to the Footwall is termed as ‘Reverse Fault’. But faults can occur within plates as fractures as well. Bishop Tuff lake sediments, Owen Valley, CA. 1. If this movement may occur rapidly, it can be causes earthquike or slowly, in the form of creep. Thrust / Reverse Fault * At bottom younger/simpler structure * At top older/complex structure Normal Fault * Draw strikes of the fault plane ( minimum 2) and from those strike identify the dip direction of fault plane.

They are caused by extensional tectonics. The red lines show the offset on the right-hand fault. A strike slip fault is also known as a transform fault. (ii) In a normal fault,the up throw move away from down throw while in a …

The only difference between the Normal Fault and Reverse Fault is that, in Normal Fault the Hanging wall is downward with respect to the Footwall whereas in a Reverse Fault the apparent movement of the Hanging wall is upwards with respect to the Footwall.

For example, the New Madrid Fault is a massive fracture in Missouri. Reverse Fault.

PHYSICAL GEOGRAPHY PRACTICE QUIZ: FOLDS AND FAULTS II.