NFPA 72 Permits Internet Monitoring. NFPA 720 Requirements Now Slated for NFPA 72 For several cycles, NFPA 72 has included requirements regarding the handling of alarm signals. Cellular dialers are also required by NFPA 72 2010 to automatically test the connection every five minutes (or every 60 minutes in recent updates), so they can be used as a single communications link while traditional units are only required to perform a test once every 24 hours. Fraker Fire Protection Inc. ensures that these requirements required by the NFPA are met. The 2019 edition of NFPA 72, National Fire Alarm and Signaling Code presents the most advanced provisions ever developed for the application, installation, location, performance, and inspection, testing, and maintenance of fire alarm and emergency communications systems -- …

1 Scope 1.1 These requirements apply to: a) Central stations providing watchman, fire-alarm, and supervisory services as described in the National Fire Alarm and Signaling Code, NFPA 72; There was a time when NFPA only required the points for “Pump running” and “Loss of power” to be monitored, so you may not have to … This change collects the requirements for smoke alarms, carbon monoxide alarms, smoke detectors, and carbon monoxide detectors in the same document. NFPA 72: Fire Alarm Requirements for High-Rise Buildings January 14, 2020 January 2, 2020 High-rises are defined as buildings 75 feet or more in height measured from the lowest level fire department vehicles can access, to the floor of the highest story accessible to occupants. NFPA 720, Installation of Carbon Monoxide (CO) Detection and Warning Equipment, will be retired in 2018, and the requirements from NFPA 720 have been integrated into NFPA 72. Did you know BuildingReports provides for the ability to include monitoring information on web-based inspection reports?. by the fire alarm system in accordance with NFPA 72 and shall comply with the following: (1) Monitoring for integrity of the system shall comply with Chapter 10 of NFPA 72. (2) System supervisory signals shall include the following: (a) Donor antenna malfunction (b) Active RF-emitting device failure The Council voted to approve the withdrawal of NFPA 720 on August 14, 2018. According to NFPA 72-2010, section 23.8.5.9, the building fire alarm system is to be used for fire pump monitoring. NFPA Supervising Station Communication Methods . Monitoring information is added on the website by users at www.BuildingReports.com. NFPA 72 requires the central station monitoring system to send out waterflow switch signals, trouble signals, alarm signals, and so on. According to NFPA 72-2010, section 23.8.5.9, the building fire alarm system is to be used for fire pump monitoring. This would principally be for those control units that are installed for the purpose of elevator recall, and that are not sending signals to an offsite monitoring station or activating local notification appliances.